3D Printing Guides
No Results Found
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.
No Results Found
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.
Resin prints stuck to build plate? Here’s the Fix
Are your prints adhering to the build platform a little too well? Your issue might be burn-in layer exposure time. Below I'll take you over what that means. I’m going to split this guide into two parts: how to get your prints off when you’ve already botched them, and...
FEP Film Replacement Guide
The FEP film is a consumable – and a good rule of thumb is to replace them every 40 or so prints, or whenever there is noticeable scratching, denting or deformation. Otherwise, you run the risk of a puncture letting resin seep onto your LCD screen during a print –...
Preview Your 3D Print Files In Folders
I searched high and low for the best means to preview a 3D print file prior to opening them up in a slicer such as Lychee or Cura. 3D files can become large and heavy in no time, and this often means loading up a file one at a time into your slicing software is a slow...
No Results Found
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.